| BACK to Page 1 |
TRIUMPH NECK KNIFE $165.00
The 3" blade is s30v steel and the overall length is 6 1/2". There are thumb serrations and finger grooves for a good grip, and holes in the handle and blade to help lighten and decorate the knife. All bead blast finish with a tungsten dlc black coating. The reverse curve blade is very good for slashing cuts.
THE KASPER CUTTER
Bead blasted Steel $140.00, SOLD OUT
Black DLC coated $155.00,
Titanium $225.00
The Kasper Cutter is one of Bob Kasper's latest designs. A very sharp pointy blade. It comes in either S30V steel or titanium, with a kydex sheath that has a removable "J" hook for inside the waist band carry.
ARM MODEL DEVIL DART WITH SPECIAL NECK SHEATH--DLC COATED $165.00
This Devil Dart is made from 44oc steel, DLC black coated and comes with two sheathes. It can be worn around the neck, on your arm or upside down on your leg. The arm sheath is made of elastic and nylon with a special plug inside for the point. The neck sheath is kydex with a stainless steel ball chain.
All steel Sleeve Daggers
These have notches around the handle for a sure grip and come double ground on the front side/flat on the back side. Made out of S30V steel for strength and edge holding. Holes in the handle help to lighten more.
These small daggers come with a kydex sheath and stainless steel ball chain so you can wear it around your neck. They also come with a nylon arm/leg sheath with elastic and VelcroŽ (shown below) for a different form of concealment.
Overall Length: 7" Cutting Edge: 3 1/4",
SLEEVE DAGGER SOLD OUT
$175.00 S30V STEEL BOTH SHEATHS.
$160.00 S30V STEEL NECK CARRY ONLY.
This knife comes in a double ground blade on one side and flat on the back side, with an arm sheath and a kydex neck sheath.
Titanium Kasper Neck Knife
Special for Self-Defense
The Titanium Kasper Neck Knife is half the weight of steel and it will not rust. Titanium takes a good edge, but will not hold it as long as steel. Titanium is expensive and hard to machine and grind, but makes a very strong, light knife.
Blade length: 3 1/2"
Overall length: 7 1/2"
Weight: approx. 2 ounces
The smaller model is 7" overall
$200.00
Sparrow Hawk
The Sparrow Hawk is a new design by Wes. It comes with a hand-rubbed satin finished blade so it will work well with the kydex sheath (included). The handle has a serrated thumb ramp and black micarta scales with an attractive red liner to set off the satin and black finish. 1/8 inch S30V stock. It's a tough little neck knife.
Overall Length: 5 1/2"
Blade Length: 2 1/2"
Satin Finish w/Black Micarta, $150.00 sold out
Black DLC coated model, $165.00 sold out
ALL STEEL DLC BLACK COATED $135.00 sold out
Eagle Feather
This is another new design neck knife by Wes. It comes with a hand-rubbed satin finished blade and micarta handle scales with a red liner. Thumb serrations for a good grip. 1/8 stock. Enough blade to do most utility work and still leaves you enough handle to comfortably grip for a small neck knife. Comes with kydex sheath, lanyard hole and stainless steel ball chain.
Overall Length: 6"
Blade Length: 2"
sold out
FIXED FALCON
